Bleed system tuning
Bleed systems provide a controlled leak path bypassing the shim stack at low speed. Low flow resistance through the bleed allows the suspension to freely return to race sag on low speed suspension motions.
Suspension “feel” heavily depends on bleed. Shock absorbers use numerous bleed system styles to get control of low speed suspension motions.o.
Damping curve "knee"
Clicker bleed circuits, leak jets, stack float or bleed shims all have a fixed constant area throat. Flow resistance is near zero at low speed and increases with velocity squared. The velocity squared pressure increase eventually produces enough backpressure to crack the shim stack open. Above the cracking pressure, the additional flow through the shim stack controlled valve produces a digressive damping force curve.
The transition from velocity squared orifice damping to shim stack controlled digressive damping puts a “knee” in the damping force curve. The location of the “knee” is controlled by the shaft velocity where the shim stack cracks open which is controlled by the bleed circuit flow area and shim stack stiffness.
Increasing the leak area provides more suspension compliance for rolling over trail trash. Decreasing the leak area provides more cornering “feel” and reduced brake dive.
Clicker needles
The clicker bleed circuit is basically a needle valve. Accurate damping force calculations require a clicker needle geometry table to describe the needle taper versus clicker position. The geometry table is a simple listing of needle diameter as a function of clicker position. Details are listed in the User Manual.
There are two basic styles of needles:
- Tapered needle: Screwing the needle in reduces the flow area
- Friction needle: Screwing the needle in increases the length of the high velocity throat increasing viscous friction losses
